§ 33108. Monitoring compliance of manufacturers

49 U.S.C. § 33108 (N/A)
Copy with citation
Copy as parenthetical citation

To enable the Secretary of Transportation to decide whether a manufacturer of motor vehicles containing a part subject to a standard prescribed under section 33102 or 33103 of this title, or a manufacturer of major replacement parts subject to the standard, is complying with this chapter and the standard, the Secretary may require the manufacturer to—

(1) keep records;

(2) make reports;

(3) provide items and information; and

(4) allow an officer or employee designated by the Secretary to inspect the vehicles and parts and relevant records of the manufacturer.

To enforce this chapter, an officer or employee designated by the Secretary, on presenting appropriate credentials and a written notice to the owner, operator, or agent in charge, may inspect a facility in which motor vehicles containing major parts subject to the standard, or major replacement parts subject to the standard, are manufactured, held for introduction into interstate commerce, or held for sale after introduction into interstate commerce. An inspection shall be conducted at a reasonable time, in a reasonable way, and with reasonable promptness.

This subsection does not apply to a motor vehicle or major replacement part that is—

(1) A manufacturer of a motor vehicle subject to the standard, and a manufacturer of a major replacement part subject to the standard, shall provide at the time of delivery of the vehicle or part a certification that the vehicle or part conforms to the applicable motor vehicle theft prevention standard. The certification shall accompany the vehicle or part until its delivery to the first purchaser. The Secretary by regulation may prescribe the type and form of the certification.

This subsection does not apply to a motor vehicle or major replacement part that is—

(A) intended only for export;

(B) labeled only for export on the vehicle or replacement part and the outside of any container until exported; and

(C) exported.

A manufacturer shall notify the Secretary if the manufacturer discovers that—

(1) there is an error in the identification (required by the standard) applied to a major part installed by the manufacturer in a motor vehicle during its assembly, or to a major replacement part manufactured by the manufacturer; and

(2) the motor vehicle or major replacement part has entered interstate commerce.

(Pub. L. 103–272, § 1(e), July 5, 1994, 108 Stat. 1083.)