Section 1001.401. Use of Seal

TX Occ Code § 1001.401 (2019) (N/A)
Copy with citation
Copy as parenthetical citation

Sec. 1001.401. USE OF SEAL. (a) On receiving a license, a license holder shall obtain a seal in a design authorized by the board, showing the license holder's name and the legend "Licensed Professional Engineer" or "Registered Professional Engineer."

(b) A plan, specification, plat, or report issued by a license holder for a project to be constructed or used in this state must include the license holder's seal placed on the document. A license holder is not required to use a seal required by this section if the project is to be constructed or used in another state or country.

(c) A person may not place a seal on a document if the license of the license holder named on the seal has expired or has been suspended or revoked.

(d) A license holder is not required to use a seal under this section for a project for which the license holder is not required to hold a license under an exemption provided by Subchapter B.

(e) A license holder shall not be required to provide or hold any additional certification, other than a license issued under this chapter, to seal an engineering plan, specification, plat, or report.

Added by Acts 2001, 77th Leg., ch. 1421, Sec. 1, eff. June 1, 2003.

Amended by:

Acts 2005, 79th Leg., Ch. 259 (H.B. 1817), Sec. 5, eff. September 1, 2005.

Acts 2007, 80th Leg., R.S., Ch. 837 (H.B. 899), Sec. 6, eff. September 1, 2007.

Acts 2009, 81st Leg., R.S., Ch. 1142 (H.B. 2649), Sec. 3, eff. June 19, 2009.