89-187.03 Permit; placed-in-service report or inspection; denial of permit; procedure.

NE Code § 89-187.03 (2019) (N/A)

Copy with citation

Copy as parenthetical citation

89-187.03. Permit; placed-in-service report or inspection; denial of permit; procedure.

Before issuing a permit to operate a weighing and measuring establishment, the director shall receive a placed-in-service report from a repairperson, who is registered with the department, or inspect each weighing and measuring device to determine whether the applicant qualifies to hold a permit pursuant to subsection (1) of section 89-187.07 except when the requirements of section 89-187.04 have been met. A placed-in-service report shall be in the form prescribed by the department. A weighing and measuring establishment receiving a placed-in-service report for all of its weighing and measuring devices, passing inspection by the department, or meeting the requirements of section 89-187.04 and otherwise found to qualify to hold a permit pursuant to subsection (1) of section 89-187.07 shall be issued a permit. An applicant who does not receive a permit shall be notified in writing of the grounds for denial, and such applicant shall be afforded the opportunity of a hearing to present evidence that the establishment is qualified to hold a permit pursuant to subsection (1) of section 89-187.07 and should be issued a permit. All such hearings shall be in compliance with the Administrative Procedure Act.

Source

Cross References

Previous Section

89-187.02 Permit; application; fee.

Next Section

89-187.04 Permit; placed-in-service report or inspection; when not required.