§ 63-5-27. Wheel and axle loads

MS Code § 63-5-27 (2019) (N/A)
Copy with citation
Copy as parenthetical citation

(1) Subject to the maximum gross single axle or tandem axle weights hereinafter specified, the gross single or tandem axle weights shall not exceed five hundred fifty (550) pounds per inch of tire width. The gross weight on any single or tandem axle thus derived shall be subject to a tolerance not in excess of five hundred (500) pounds provided that the total allowable gross weight of the single or tandem axle shall not exceed the maximum limitations allowed hereinafter.

(2) The gross weight imposed on the highway by the wheels of any one (1) single axle of a vehicle shall not exceed twenty thousand (20,000) pounds exclusive of the tolerance provided in Section 63-5-33. A single axle shall be defined as an assembly of two (2) or more wheels whose centers are in one (1) transverse vertical plane or may be included between two (2) parallel transverse vertical planes forty (40) inches apart extending across the full width of the vehicle.

(3) The gross weight imposed on the highway by any tandem axle shall not exceed thirty-four thousand (34,000) pounds exclusive of the tolerance provided in Section 63-5-33. A tandem axle shall be defined as any two (2) or more consecutive axles whose centers are more than forty (40) inches but not more than ninety-six (96) inches apart. No one (1) axle of any such group of two (2) or more consecutive axles shall exceed the weight permitted for a single axle.

(4)

(a) Vehicles designed and especially constructed to transport concrete products and which are not available for purchase in sizes and capacities to fully comply with the road and bridge weight laws of the State of Mississippi shall not be made to conform to the axle spacing requirements or axle or tire loadings of this section or to the total combined weights as set out in Section 63-5-33 in Table III, provided (i) that such vehicles shall be limited to a gross weight of sixty thousand (60,000) pounds; (ii) that such vehicles shall only be operated within fifty (50) miles of their home base; (iii) that any such vehicles shall be limited to a maximum load of the rated capacity of the vehicle; (iv) that all such vehicles shall have at least three (3) axles; and (v) that all vehicles with only three (3) axles shall have all wheels brake-equipped. Any two (2) or more axles close enough to be considered an axle group shall be suspended by an equalizing system and be spaced a minimum of four (4) feet apart in order to be eligible for the maximum load as provided in this subsection. It shall be a violation if vehicles to which this subsection applies travel upon any federal interstate highway or upon any roads or bridges designated and posted as incapable of carrying such loads by the Transportation Commission, a board of supervisors, or municipal governing authorities as provided in subsection (5) or (6) of this section.

(b) Vehicles designed and especially constructed to transport raw cotton from harvest to the cotton gin shall not be made to conform to the axle spacing or axle or tire loadings of this section. However, such vehicles (i) shall be limited to a gross weight of sixty thousand (60,000) pounds; (ii) may be operated only within a fifty-mile radius of their home base or their contractual customer; (iii) shall be limited to a maximum load of the rated capacity of that vehicle; (iv) shall have all wheels brake equipped; and (v) are prohibited from traveling upon any federal interstate highway or upon any roads or bridges designated and posted as incapable of carrying such loads by the Mississippi Department of Transportation, a board of supervisors or municipal governing authorities as provided in subsection (5) or (6) of this section.

(c) Vehicles designed and especially constructed to collect and transport solid waste and which are not available for purchase in sizes and capacities to fully comply with the road and bridge weight laws of the State of Mississippi, shall not be made to conform to the axle spacing or tire loadings of this section. However, such vehicles (i) shall be limited to a gross weight of sixty thousand (60,000) pounds; (ii) may be operated only within a fifty-mile radius of their home base or their contractual customer; (iii) shall be limited to a maximum load of the rated capacity of that vehicle; (iv) shall have all wheels brake-equipped; and (v) are prohibited from traveling upon any federal interstate highway or upon any roads or bridges designated and posted as incapable of carrying such loads by the Mississippi Department of Transportation, a board of supervisors or the governing authorities of a municipality as provided in subsection (5) or (6) of this section.

(d) The rear axle of trailer mounted knuckle boom log loaders shall be exempt from the tire loading limitation provided for in subsection (3) of this section; provided, however, that the gross weight imposed on the highway by such an axle shall not exceed forty-one thousand (41,000) pounds.

(5) The board of supervisors of any county or the governing authorities of any municipality, by appropriate resolution, may impose limitations more restrictive than those permitted in this section upon the county highways of such county or the streets of such municipality.

(6) The Mississippi Department of Transportation, for cause, may post or limit any road or bridge to weights less than those permitted by this section.